I have successfully completed first chair for my grand daughter.
Few glitches with the latest FW and software.
The panel detection was
much more smoother and if the tower sensors are not connected then turn off(hold tower button for few seconds till the led turns red and will be off) and on again then the tower sensors led stops blinking and successful connection.
I have used Okume face ply 15mm half the price then birch ply.( birch ply is much better though)
Initially there was a chatter and I stopped the project to save the wood then ran it whih slower depth per pass from 5 mm to 3mm.
The tabs did not make any difference I should have increased the height to more than 2mm.
As the cut panels move casuing positioning error- none the less completed the project.